The SM Shakanah! Mirror Image 3D Printed Limited Edition Resin of 50 is a special run. He is hollow printed with RFID, Magne-Click and color COA. He comes with a 2″ metal disc (not shown) and has supports removed, sanded and sprayed with Stynylrez Fine Airbrush Primer in gray close to the printed resin color. For photographing, we placed him on heavy photography background paper on top of a stainless steel table which he sticks to quite nicely. He will stick to any flat ferrous metal if you chose not to use the round disc which comes with him. The metal disc gives you enough room to add ground cover for a mini diorama if you want to get creative, just make sure to leave enough room for the resin base and back hoof so they touch the metal as a flat surface. This little guy is packed with so much authenticity, that you will look at the photo and think he is WAY bigger than he really is. Below is the link to purchase either in full or on time payments with a subscription which we will set up once you make your initial first payment. Once you make a purchase, Larry will process your order in the next few days and send you an email with confirmation. Shipping will begin in a couple of weeks as it takes time to cleaning them up and apply primer. It will take some time to get them all done because I didn’t plan on adding this special run on top of what we’ve already sold but I will do them and will save you some time because I’m doing most of the work for you. If you have any questions, please contact me. I’m pretty much chained to my workbench without the exception of sleeping for a few hours each night.